Table of Contents
Advertisement
2430GDAC G-Link D to A Converter
2.
INSTALLATION
The 2430GDAC-WARP is a compact module that has two BNC connectors, one fiber optic connector,
one DVI-I connector for video, and one DB-9 serial port connector for upgrades.
2.1.
POWER
The 2430GDAC-WARP comes with an auto-ranging DC voltage adapter that
automatically senses the input voltage. Power should be applied by connecting a
3-wire grounding type power supply cord to the power entry module on the DC
voltage adapter. The power cord should be minimum 18 AWG wire size; type SST
marked VW-1, maximum 2.5 m in length. The DC cable of the voltage adapter
should be connected to the DC power jack on the rear panel. A green LED located
beside the DVI Out connector will be illuminated when there is power applied to the
2430GDAC-WARP.
2.2.
GLINK IN AND OUT
FIBER GLINK IN: Input fiber connector for G-Link video signals over fiber optic cable.
GLINK IN:
Input BNC connector for G-Link video signals over coaxial cable.
GLINK OUT:
Output BNC connector for reclocked G-Link video signals over coaxial cable.
2430GDAC-2
Figure 2-1: 2430GDAC-WARP Module Connections
Revision 1.2
Advertisement
Table of Contents
