Table of Contents
Advertisement
2.
INSTALLATION
The 2405EO is a compact module that has three BNC connectors and one SC/PC (shown), ST/PC or
FC/PC optical connector.
SDI INPUT:
Input BNC connector for 10-bit serial digital video signals compatible with the
SMPTE 259M, DVB-ASI or SMPTE 310M standard.
choosing the correct video standard.
SDI OUTPUT: There are two BNC connectors with reclocked serial component video outputs, compatible
with the SMPTE 259M or SMPTE 310M standard. Only the SDI OUTPUT closest to the SDI
OUPUT Fiber connector maintains the correct polarity for DVB-ASI signals.
There is one SC/PC (shown), ST/PC or FC/PC female connector with reclocked serial
component video outputs, compatible with the SMPTE 259M, DVB-ASI or SMPTE 310M
standard. This connector is the optical output from the 2405EO as shown in section 3.3.
The 2405EO comes with an auto-ranging DC voltage adapter that automatically senses the
input voltage. Power should be applied by connecting a 3-wire grounding type power supply
cord to the power entry module on the DC voltage adapter.
minimum 18 AWG wire size; type SST marked VW-1, maximum 2.5 m in length. The DC cable
of the voltage adapter should be connected to the DC power jack on the rear panel. A green
LED located beside the power connector will be illuminated when there is power applied to the
2405EO.
2405EO SMPTE259M Re-Clocking Electrical to Fiber Converter
Figure 2-1: 2405EO Module
Revision 2.1
2400 Series Fiber Converter Manual
See section 5.1 for information on
The power cord should be a
2405EO-3
Advertisement
Table of Contents
