Table of Contents
Advertisement
2430GDAC-MWP G-Link D to A Converter for MWP
2.
INSTALLATION
The 2430GDAC-MWP is a compact module that has two BNC connectors, one fiber optic connector, one
DVI-I connector for video, and one DB-9 serial port connector for upgrades.
2.1.
POWER
The 2430GDAC-MWP comes with an auto-ranging DC voltage adapter that
automatically senses the input voltage. Power should be applied by connecting a 3-
wire grounding type power supply cord to the power entry module on the DC voltage
adapter. The power cord should be minimum 18 AWG wire size; type SST marked
VW-1, maximum 2.5 m in length. The DC cable of the voltage adapter should be
connected to the DC power jack on the rear panel. A green LED located beside the
DVI Out connector will be illuminated when there is power applied to the
2430GDAC-MWP.
2.2.
GLINK IN AND OUT
GLINK FIBER IN: Input fiber connector for G-Link video signals over fiber optic cable.
GLINK IN:
Input BNC connector for G-Link video signals over coaxial cable.
GLINK OUT:
Output BNC connector for reclocked G-Link video signals over coaxial cable.
2430GDAC-MWP-2
Figure 2-1: 2430GDAC-MWP Module Connections
Revision 1.1
Advertisement
Table of Contents
