7700 MultiFrame Manual
7735CEM Composite Encoder with Monitoring
7.10.12.
Detecting Picture Black Duration
Fault definitions
Picture black duration
4 to 900 frames
88 frames
7.11. UTILITIES
7.11.1. Accessing Information About this Module and its Firmware
Utilities
About...
7.11.1.1. Storing Configurations to the User Presets
Utilities
Store preset 1
Store
Cancel
7.11.1.2. Recall Configurations from the User Presets
Utilities
Recall preset 1
Recall,
Cancel
7735CEM-52
Gray background indicate un-implemented or un-tested features
This control sets duration, in seconds, of active picture content below 7
IRE that is considered a fault.
A Fault is generated when the video level within the active picture area
falls below the preset black level (7 IRE) and remains for the specified
duration.
This menu item lists the particulars about this module and the firmware
residing within it. It gives quick access to information about revisions that
can be used to determine when upgrades are required.
This control is used to initiate a store of the current card configuration into
one of the user presets
After selecting the store preset operation, you must change the command
to Store and press the pushbutton before the store will take place. You
can abort the operation by pressing the pushbutton when Cancel is
displayed.
This control is used to initiate a recall of the current card configuration
from one of the user presets.
After selecting the recall preset operation, you must change the command
to Recall and press the pushbutton before the store will take place. You
can abort the operation by pressing the pushbutton when Cancel is
displayed.
Warning: there will be a slight disturbance in the operation of the card
and the on-screen display while the new preset is being recalled.
Warning: the current state of the card will be forgotten if it has not been
saved to a preset before a recall is performed.
Revision 1.1.1