Table of Contents
Advertisement
2400 Series Fiber Converter Manual
2405EO SMPTE259M Re-Clocking Electrical to Fiber Converter
2405EO3F
2405EO3D-L
2405EO5D-L
2405EO47
2405EO49
2405EO51
2405EO53
2405EO55
2405EO57
2405EO59
2405EO61
3.4.
ELECTRICAL
Voltage:
Power:
EMI/RFI:
DC Power Supply:
3.5.
PHYSICAL
Dimensions:
With Mounting Flanges: 6" L x 4" W x 1" H
Weight:
4.
STATUS LEDS
ACTIVE SIGNAL:
NO CARRIER:
SIGNAL WEAK:
LASER FAULT
5.
USER CONTROLS
The 2405EO is equipped with a 4 position DIP switch to allow the user to configure the module. The On
position is down, or closest to the printed circuit board. Table 1 gives an overview of the DIP switch
functions. Section 5.1 gives specific information about the DIP switch functions.
2405EO-6
Wavelength
1310 nm
1310 nm
1550 nm
1470 nm
1490 nm
1510 nm
1530 nm
1550 nm
1570 nm
1590 nm
1610 nm
+ 12VDC
6 Watts.
Complies with FCC regulations for class A devices.
Complies with EU EMC directive.
115/230 VAC 50/60 Hz, 30 VA
6" L x 3.5" W x 1" H
(152mm L x 89mm W x 25mm H)
(152mm L x 114mm W x 25mm H)
0.5 lbs. (0.28 Kg)
This Green LED will be On when there is a valid signal present at the module input.
This Red LED will be On when there is no valid signal present at the module input.
This Yellow LED will be On when the cable equalizer detects that the cable length is
greater than a preset threshold. (factory set for 250 meters of Belden 8281 or
equivalent cable). See section 5.2 for information on adjusting the cable equalizer
warning threshold.
This Red LED will be On when there is a fault in the optical output device.
Structure
Fabrey Perot
DFB
DFB
DFB
DFB
DFB
DFB
DFB
DFB
DFB
DFB
Revision 2.0
Power
< 4.5 nm
-7.5 dBm
< 1 nm
0 dBm
< 1 nm
0 dBm
< 1 nm
> 0 dBm
< 1 nm
> 0 dBm
< 1 nm
> 0 dBm
< 1 nm
> 0 dBm
< 1 nm
> 0 dBm
< 1 nm
> 0 dBm
< 1 nm
> 0 dBm
< 1 nm
> 0 dBm
Advertisement
Table of Contents
