Packing An Ex9200 Switch Or Component; Packing An Ex9200 Switch - Juniper EX9214 Hardware Manual

Packing an EX9200 Switch or Component

IN THIS SECTION

Packing an EX9200 Switch | 327

Packing EX9200 Switch Components for Shipping | 328
If you are returning an EX9200 switch or component to Juniper Networks for repair or replacement,
pack the item as described in this topic.
Before you begin packing the switch or component, ensure you have:
• Followed all the steps listed in
• Retrieved the original shipping carton and packing materials. Contact your JTAC representative if you
do not have these materials, to learn about approved packing materials. See
Support to Obtain Return Material Authorization
• Ensure you understand how to prevent electrostatic discharge (ESD) damage. See
Electrostatic Discharge Damage
Ensure that you have the following parts and tools available:
• An ESD wrist strap
Packing an EX9200 Switch
If you need to transport the switch to another location or return the switch to Juniper Networks, you
need to pack the switch securely in its original packaging to prevent damage during transportation.
To pack the switch for shipment:
1. Retrieve the shipping crate and packing materials in which the switch was originally shipped. If you
do not have these materials, contact your Juniper Networks representative about approved
packaging materials.
2. On the console or other management device connected to the primary Routing Engine, enter CLI
operational mode and issue the following command to shut down the switch software. (If two
Routing Engine modules are installed, also issue the command on the backup Routing Engine.)
user@switch> request system halt
Contact Customer Support to Obtain Return Material Authorization
.
.
.
Contact Customer
Prevention of
327