Juniper EX9214 Hardware Manual page 75

• MGMT port—Connects the EX9200-RE2 module through an Ethernet connection to a management
LAN (or any other device that plugs into an Ethernet connection) for out-of-band management. See
Connecting an EX9200 Switch to a Network for Out-of-Band Management
• Status LEDs—Indicate the status of the EX9200-RE2 module. Each EX9200-RE2 module has five
LEDs labeled MASTER, ONLINE, OK/FAIL, DISK1, and DISK2 on the faceplate.
• ONLINE/OFFLINE button—Turns the EX9200-RE2 module online or offline when pressed.
• USB1 and USB2 ports—Host a removable media interface using which you can install the Junos OS
USB Port Specifications for an EX Series Switch
manually. See
• SSD 1 and SSD 2 slots—Host primary storage for software images, configuration files, and microcode.
Also provide secondary storage for log files and memory dump files.
• RESET button—Reboots the EX9200-RE2 module when pressed.
• Captive screws—Secure the EX9200-RE2 module in place.
For the specifications of the Routing Engine modules, see
Table 21: Routing Engine Module Specifications
RE Module Processor
EX9200-RE RE-S-
EX9200-1800X4
(4 cores, 1.73 GHz)
EX9200-RE2 RE-S-
EX9200-2X00x6
(6 cores, 2 GHz)
Table 21 on page
Memory Connecti Disk
on to
Packet
Forwardin
g Engines
16 GB Gigabit 32- GB hard
Ethernet disk
64 GB Gigabit 50- GB SSD
Ethernet X 2
.
.
64.
Media
4- GB
CompactFlash
card
No flash
memory
64
First Junos
OS
Release
12.3R2
17.1R1