Juniper EX9214 Hardware Manual page 103

1 Ejector lever
—
2 Line card LED
—
You can use the
show version
the switch.
Line Card Components
The EX9200-MPC line card has:
• Two slots that can accept any of the following MICs:
• EX9200-10XS-MIC, which has ten 10-Gigabit Ethernet ports, each of which can house small
form-factor pluggable plus (SFP+) transceivers. The ports form one port group. The ports support
10GBASE-SR, 10GBASE-LR, 10GBASE-ER, and 10GBASE-ZR transceivers. An LED labeled OK/
FAIL on the MIC indicates the status of the MIC. See
Switch
. The MIC is shipped with 10 dust covers for the 10 ports. See
Figure 30: EX9200-10XS-MIC
LEDs for the ports
1
—
10-Gigabit Ethernet ports
2
—
• EX9200-20F-MIC, which has twenty 1-Gigabit Ethernet ports with Media Access Control Security
(MACsec) capability, each of which can house 1-gigabit small form-factor pluggable (SFP)
transceivers. The EX9200-20F-MIC in EX9200-MPC line card supports 802.1AE IEEE MAC
Security standard (also known as MACsec) with AES-128 bit encryption, providing support for
link-layer data confidentiality, data integrity, and data origin authentication. You must apply a
single license—EX9200-SFL—to enable MACsec. The ports are divided into two port groups of ten
ports each. The ports labeled [0/2]/0 through [0/2]/8 and [1/3]/0 through [1/3]/8 form one port
group and the ports labeled [0/2]/1 through [0/2]/9 and [1/3]/1 through [1/3]/9 form another
port group. These ports support 1000BASE-T, 1000BASE-SX, 100BASE-FX, 1000BASE-LX,
1000BASE-BX-U, 1000BASE-BX-D, 100BASE-BX-U, 100BASE-BX-D, and 1000BASE-LH
command to see the version of Junos OS for EX Series switches loaded on
3 MIC slots covered by cover panels
—
Modular Interface Card LED in an EX9200
Figure 30 on page
MIC power button
3
—
MIC LED
4
—
92
92.