Juniper EX9214 Hardware Manual page 176

Parts and Tools Required for Connecting an EX Series Switch to Earth Ground
Before you begin connecting an EX Series switch to earth ground, ensure you have the parts and tools
required for your switch.
Table 58 on page 165 lists the earthing terminal location, grounding cable and lug specifications, and
parts needed for connecting an EX Series switch to earth ground.
Table 58: Parts Required for Connecting an EX Series Switch to Earth Ground
Switch Earthing
Terminal
Location
EX2200 Rear panel of
the chassis
EX2300-C Rear panel of
the chassis
Grounding Grounding Lug
Cable Specifications
Requirements
14 AWG Panduit
(2 mm²), LCC10-14BWL or
minimum 90° C equivalent—
wire, or as not provided
permitted by
the local code
14 AWG Panduit
(2 mm²), LCC10-14AW-L or
minimum 90° C equivalent—
wire, or as not provided
permitted by
the local code
Screws and Additional
Washers Information
•
Two
10-32 x .25 i
n. screws
with #10
split-lock
washer—
not provided
•
Two #10 flat
washers—
not provided
•
Two
10-32 x .25 i
n. screws
with #10
split-lock
washer—
not provided
•
Two #10 flat
washers—
not provided
165