Chassis Component Alarm Conditions On Ex9200 Switches - Juniper EX9214 Hardware Manual

SEE ALSO
Dashboard for EX Series Switches

Chassis Component Alarm Conditions on EX9200 Switches

IN THIS SECTION
Backup Routing Engine Alarms | 299
This topic describes the chassis component alarm conditions on EX9200 switches.
Table 61 on page 293 lists the alarms that the chassis components can generate on EX9200 Switches.
Table 61: Chassis Component Alarm Conditions on EX9200 Switches
Chassis Alarm Condition
Component
Air filters Change air filter.
Alternative The switch boots from an
media alternate boot device, the hard
disk. The CompactFlash card is
typically the primary boot
device. The Routing Engine
boots from the hard disk when
the primary boot device fails.
Craft interface The craft interface has failed.
Line Cards A line card is offline.
Alarm Remedy
Severity
Minor Replace the air filter.
(yellow)
Minor Open a support case using the Case
(yellow) Manager link at
support/ or call 1-888-314-5822 (toll free,
US & Canada) or 1-408-745-9500 (from
outside the United States).
Major (red) Replace the failed craft interface.
Minor Check the line card. Remove and reinstall
(yellow) the line card. If this fails, replace the failed
card.
https:/ /www.juniper.net/
293