Juniper EX9214 Hardware Manual page 124

2. Configure the pic-mode statement to set the operating speed for the ports of a PIC. You can choose
from the options 10G, 40G, or 100G.
fpc-slot pic pic-number ]
[edit chassis fpc
user@host# set pic-mode
For example:
[edit chassis fpc 4 pic 0]
user@host# set pic-mode 10G
3. (Optional) You can choose to configure the number of ports that operate at the speed configured in
Step 2.
fpc-slot pic pic-number ]
[edit chassis fpc
user@host# set number-of-ports
For example, to specify that six ports on PIC 0 operate at the speed specified in Step 2:
[edit chassis fpc 4 pic 0]
user@host# set number-of-ports 6
4. Verify the configuration.
[edit chassis fpc 4 pic 0]
user@host# show
pic-mode 10G;
number-of-ports 6;
5. Commit your configuration changes.
6. Reset the PIC.
If the number-of-ports statement is
2 are enabled and the others are disabled. That is, the ports are enabled depending on whether or not
they support the speed specified. Ports 0 through 5 are enabled if the speed specified is 10 Gbps or 40
Gbps; and ports 2 and 5 are enabled and the other ports of the PIC disabled if the speed specified is 100
Gbps. Table 17 lists the physical ports that are enabled when the number-of-ports statement is configured.
pic-speed
number-of-active-physical-ports
not configured, all the ports that support the speed configured in Step
113