Juniper EX9214 Hardware Manual page 308

Table 61: Chassis Component Alarm Conditions on EX9200 Switches
Chassis Alarm Condition
Component
System booted from hard disk.
CompactFlash card missing in
boot list.
Hard disk missing in boot list.
Routing Engine failed to boot.
The Ethernet management
interface (fxp0 or em0) on the
Routing Engine is down.
/var partition usage is high.
/var partition is full.
Rescue configuration is not set.
(Continued)
Alarm Remedy
Severity
Minor Install the bootable image on the
(yellow) CompactFlash card. If this fails, replace
failed the Routing Engine.
Major (red) Replace the failed Routing Engine.
Major (red) Replace the failed Routing Engine.
Major (red) Replace the failed Routing Engine.
Major (red)
•
Check the interface cable connection.
•
Reboot the system.
•
If the alarm recurs, open a support case
using the Case Manager link at
www.juniper.net/support/
1-888-314-5822 (toll free, US &
Canada) or 1-408-745-9500 (from
outside the United States).
Minor Clean up the system file storage space on
(yellow) the switch. For more information, see
Freeing Up System Storage
Major (red) Clean up the system file storage space on
the switch. For more information, see
Freeing Up System Storage
Minor request system configuration
Use the
(yellow)
rescue save
configuration.
https:/ /
or call
Space.
Space.
command to set the rescue
297