Juniper EX9214 Hardware Manual page 109

• For the EX9200-15C line card to be operational, you must install the EX9200-SF3 Switch
Fabric module (SF module) in the switch. See
• To achieve maximum line-rate performance, the line card's fabric redundancy mode must be
configured in increased bandwidth mode.
• To achieve maximum performance, the following number of EX9200-SF3 SF modules must be
installed in the system:
• EX9214—Three EX9200-SF3 SF modules
• EX9204 and EX9208—Two EX9200-SF3 SF modules
Figure 34 on page 98 shows the components of an EX9200-15C line card.
Figure 34: EX9200-15C Line Card
1 OK/FAIL LED
—
Lane LEDs
2
—
3 Network ports
—
You can use the
show version
the switch.
Line Card Components
The EX9200-15C line card has:
• Fifteen network ports that can be configured for 10-Gbps, 25-Gbps, 40-Gbps, or 100-Gbps
(breakout cables are used for 10-Gbps and 25-Gbps speeds).
• The Switch Processor Mezzanine Board (SPMB) consists of a 1.6-GHz Intel Broadwell 8-core CPU,
100-GB SATA SSD, and two 16-GB ECC DDR4 DRAM modules.
• Three Packet Forwarding Engines, each providing a maximum bandwidth of 500 Gbps.
command to see the version of Junos OS for EX Series switches loaded on
EX9200-SF3 Module in an EX9200 Switch
4 Physical Presence button
—
Port LEDs
5
—
98
.