Packing An Ex2200 Switch Or Component For Shipping; Packing A Switch For Shipping - Juniper EX2200 Hardware Manual

EX2200 and EX2200-C Switches Hardware Guide

Packing an EX2200 Switch or Component for Shipping

172
If you are returning an EX2200 switch or component to Juniper Networks for repair or
replacement, pack the item as described in this topic.
Before you begin, ensure that you have retrieved the original shipping carton and packing
materials. Contact your JTAC representative if you do not have these materials, to learn
about approved packing materials. See
Material Authorization" on page
Ensure that you have the following parts and tools available:
Antistatic bag, one for each switch or component
Phillips (+) screwdriver, number 2
Packing a Switch for Shipping on page 172
Packing Switch Components for Shipping on page 173

Packing a Switch for Shipping

To pack a switch for shipping:
On the console or other management device connected to the switch, enter the CLI
1.
operational mode and issue the following command to shut down the switch software:
user@switch> request system halt
Wait until a message appears on the console confirming that the operating system
has halted.
Disconnect power from the switch by performing one of the following:
2.
If the power source outlet has a power switch, set it to the OFF (0) position.
If the power source outlet does not have a power switch, gently pull out the male
end of the power cord connected to the power source outlet.
Remove the cables that connect the switch to all external devices. See
3.
a Fiber-Optic Cable" on page
Remove all optical transceivers installed in the switch. See
4.
on page 141.
If the switch is mounted on a wall or on two posts, have one person hold the switch
5.
while another person unscrews and removes the mounting screws.
Use the Phillips (+) screwdriver, number 2 to remove the screws.
6.
Remove the switch from the wall, rack, cabinet, or desk and place the switch in an
7.
antistatic bag.
"Contacting Customer Support to Obtain Return
171.
147.
Copyright © 2018, Juniper Networks, Inc.
"Disconnecting
"Removing a Transceiver"