Packing Ex9200 Switch Components For Shipping - Juniper EX9214 Hardware Manual

Wait until a message appears on the console confirming that the operating system has halted.
For more information about the command, see the
3. Wrap and fasten one end of the ESD wrist strap around your bare wrist, and connect the other end
of the strap to the ESD point on the switch.
4. Shut down power to the switch by pressing the AC input switch or DC circuit breaker for all power
supplies to the off position.
5. Disconnect power from the switch.
6. Remove the cables that connect to all external devices.
7. Remove all field replaceable units (FRUs) from the switch.
8. Remove the switch from the rack:
• If you are using a mechanical lift, place the lift platform under the switch, unscrew and remove
the mounting screws from the rack, and move the switch to the shipping crate.
• If you are not using a mechanical lift and the switch weight is fully supported by a shelf or
another switch, unscrew and remove the mounting screws from the rack. Three people can then
lift the switch and move it to the shipping crate.
• If you are not using a mechanical lift and the switch weight is not fully supported by a shelf or
another switch, three people must grasp the switch while a fourth person unscrews and
removes the mounting screws from the rack. The three people can then move the switch to the
shipping container.
9. Place the switch in the shipping crate or onto the pallet. If on a pallet, bolt the switch to the pallet.
10. Cover the switch with an antistatic bag and place the packing foam on top of and around the
switch.
11. Replace the accessory box on top of the packing foam.
12. Securely tape the box closed or place the crate cover over the switch.
13. Write the RMA number on the exterior of the box to ensure proper tracking.

Packing EX9200 Switch Components for Shipping

Before you begin packing a switch component, ensure that you have the following parts and tools
available:
• Antistatic bag, one for each component
• An ESD wrist strap
To pack EX9200 switch components, follow the instructions here.
CLI Explorer.
328