Juniper EX9214 Hardware Manual page 269

ejector levers on either side of the faceplate of the line card and pull them outward simultaneously
until the MIC is fully unseated (see
7. Grasp the handles on the MIC faceplate and slide the MIC out of the line card.
CAUTION: Do not stack MICs on top of one another or on top of any other
component. Place each MIC separately in the antistatic bag or on the antistatic mat
placed on a flat, stable surface.
8. Place the MIC in an antistatic bag or on its own antistatic mat placed on a flat, stable surface.
9. Install both the MIC slot cover panels if you will not install any MIC in the MIC slots, or install one
cover panel in the empty portion of the MIC slot if you will install only one EX9200-10XS-MIC or
EX9200-20F-MIC. Do this to protect the interior of the line card and the switch chassis from dust or
Figure 81 on page 260).
258