Juniper EX9214 Hardware Manual page 74

• ETHERNET port—Connects the EX9200-RE module through an Ethernet connection to a
management LAN (or any other device that plugs into an Ethernet connection) for out-of-band
Connecting an EX9200 Switch to a Network for Out-of-Band Management
management. See
• USB port—Hosts a removable media interface through which you can install the Junos OS manually.
USB Port Specifications for an EX Series Switch
See
• SATA SSD 1 and SATA SSD 2 slots—Host primary storage for software images, configuration files,
and microcode. Also provide secondary storage for log files and memory dump files.
• RESET button—Reboots the EX9200-RE module when pressed.
• ONLINE/OFFLINE button—Turns the EX9200-RE module online or offline when pressed.
• Status LEDs—Indicate the status of the EX9200-RE module. Each EX9200-RE module has four LEDs
labeled MASTER, STORAGE, ONLINE, and OK/FAIL on the faceplate.
• Captive screws—Secure the EX9200-RE module in place.
Figure 22 on page 63 shows the EX9200-RE2 module in an EX9200 switch.
Figure 22: EX9200-RE2 Module in an EX9200 Switch
Extractor clips
1
—
Auxiliary port (AUX)
2
—
3 Console port (CONSOLE)
—
4 Management port (MGMT)
—
5 LEDs—ONLINE, OK/FAIL, and MASTER
—
Each EX9200-RE2 module consists of the following components:
• Extractor clips—Control the locking system to securely install and remove the EX9200-RE2 module.
• AUX port—Connects the EX9200-RE2 module to a modem or other auxiliary device.
• CONSOLE port—Connects the EX9200-RE2 module to a system console through a cable with an
RJ-45 connector. See
Device
.
Connecting an EX9200 Switch to a Management Console or an Auxiliary
.
ONLINE/OFFLINE button
6
—
SSD LEDs—DISK1 and DISK2
7
—
8 USB ports—USB1 and USB2
—
9 RESET button
—
10 SSD slots—SSD 1 and SSD 2
—
63
.