Juniper EX9214 Hardware Manual page 311

Table 62: Backup Routing Engine Alarms
Chassis Alarm Condition
Component
Alternative The backup Routing Engine
media boots from an alternate boot
device, the hard disk. The
CompactFlash card is typically
the primary boot device. The
Routing Engine boots from the
hard disk when the primary
boot device fails.
Boot Device The boot device (CompactFlash
or hard disk) is missing in boot
list on the backup Routing
Engine.
Ethernet The Ethernet management
interface (fxp0 or em0) on the
backup Routing Engine is
down.
FRU Offline The backup Routing Engine has
stopped communicating with
the primary Routing Engine.
Hard Disk Error in reading or writing hard
disk on the backup Routing
Engine.
Alarm Remedy
Severity
Minor Open a support case using the Case Manager
(yellow) link at https:/ /www.juniper.net/support/
1-888-314-5822 (toll free, US & Canada) or
1-408-745-9500 (from outside the United
States).
Major (red) Replace the failed backup Routing Engine.
Minor
•
Check the interface cable connection.
(yellow)
•
Reboot the system.
•
If the alarm recurs, open a support case
using the Case Manager link at
www.juniper.net/support/
1-888-314-5822 (toll free, US & Canada) or
1-408-745-9500 (from outside the United
States).
Minor Open a support case using the Case Manager
(yellow) link at https:/ /www.juniper.net/support/
1-888-314-5822 (toll free, US & Canada) or
1-408-745-9500 (from outside the United
States).
Minor Reformat hard disk and install bootable image.
(yellow) If this fails, replace failed backup Routing
Engine.
300
or call
https:/ /
or call
or call