Chapter 12 Troubleshooting; Checking For The Error Codes And The Warning Codes - Mitsubishi Electric NZ2GF2B1-16D User Manual

CHAPTER 12
This chapter describes error contents that may occur while the I/O module is used and those troubleshooting.
12.1

Checking for the Error Codes and the Warning Codes

Error codes can be checked by any of the following methods:
• Checking by executing a command of the slave station ( Page 235, Section 12.1 (1))
• Checking by Error code (RWr1) ( Page 237, Section 12.1 (2))
Warning codes can be checked by any of the following methods:
• Checking by executing a command of the slave station ( Page 235, Section 12.1 (1))
• Checking by Warning code (RWr2) ( Page 237, Section 12.1 (3))
(1) Checking by executing a command of the slave station
This section describes how to check the errors by executing a command of the slave station.
List of stations
TROUBLESHOOTING
1.
Select the main I/O module in "List of stations" on
the "CC IE Field Configuration" window.
2.
Open the "Command Execution of Slave Station"
window.
3.
Set "Method selection" to "Error history read" and
click the

CHAPTER 12 TROUBLESHOOTING

[CC IE Field Configuration]  [Online] 
[Command Execution of Slave Station]
button.
12
235