CHAPTER 11
This chapter describes errors that may occur when the temperature control module is used, and those troubleshooting.
11.1
Checking for Error Codes and Alarm Codes
Error codes can be checked by any of the following methods:
• Checking with the command execution of slave station (Page 267, Section 11.1 (1))
• Checking with Latest error code (RWr0) and Error occurrence address (RWr1) (Page 270, Section 11.1
(2))
• Checking with Latest warning code (RWr2) (Page 270, Section 11.1 (3))
Alarm codes can be checked by any of the following methods:
• Checking with the command execution of slave station (Page 267, Section 11.1 (1))
• Checking with Latest warning code (RWr2) (Page 270, Section 11.1 (3))
(1) Checking with the command execution of slave station
The following shows how to check errors with the command execution of slave station.
List of
stations
TROUBLESHOOTING
1.
Select the temperature control module in "List of
stations" on the CC IE Field Configuration window.
2.
Open the "Command Execution of Slave Station"
window.
CHAPTER 11 TROUBLESHOOTING
[CC IE Field Configuration] [Online]
[Command Execution of Slave Station]
11
267