Pc Programming - Panasonic KX-NS700 Feature Manual

A pause is not automatically inserted between the user-dialed access code and the subsequent digits
when the ARS mode is enabled. (→ 2.1.3 ARS (Automatic Route Selection))
PC Programming Manual References
9.24 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port—Pause Time
10.3 PBX Configuration—[2-3] System—Timers & Counters—Miscellaneous—During Conversation—Pause
Signal Time (s)
14.4 PBX Configuration—[6-4] Feature—Second Dial Tone
PT Programming Manual References
[416] LCOT Pause Time

15.1.4 PC Programming

Description
This PBX can be programmed and administered using a PC. There are two programming methods:
1.
On-site Programming: System programming/diagnosis can be performed locally by connecting a PC
to the PBX directly.
2.
Remote Programming: System programming/diagnosis and data upload can be performed from a
remote location.
1.
On-site Programming:
Method
Using the LAN interface
Using a modem through
an SLT port
Using an ISDN TA
interface (64 kbps)
through an ISDN
Extension Line
If remote access is disabled through system programming, then this on site programming cannot be done.
*1
2.
Remote Programming:
Document Version 2017-06
Available via the LAN port of the MPR card.
An RMT card must be installed. Assign the floating extension number
of the analog remote maintenance (default: 599), and dial this
*1
number from the PC to connect to the PBX.
Assign the floating extension number of the ISDN remote
maintenance (default: 699), and dial this number from the PC to
connect to the PBX. The RMT card is not required for this method.
This method is available only when a user-supplied ISDN TA that
*1
supports CAPI is used.
15.1.4 PC Programming
Description
Feature Manual 249