Panasonic KX-NS700 Feature Manual page 437
Hybrid ip-pbx
Hide thumbs
Also See for KX-NS700:
- Feature manual (580 pages) ,
- User manual (394 pages) ,
- Operating manual (362 pages)
Table of Contents
Advertisement
1.
Service Mode Assignment
Assign the service mode, VM service or AA service, to the VM (DTMF) group to correspond with the
assignment of the VPS.
→ 11.12.2 PBX Configuration—[3-12-2] Group—VM(DTMF) Group—Group Settings—Type
2.
DTMF Command Assignment
Assign the DTMF command to suit the VPS settings.
11.12.2 PBX Configuration—[3-12-2] Group—VM(DTMF) Group—Group Settings
→
VM DTMF Command—Recording Message
→
VM DTMF Command—Listening Message
→
VM DTMF Command—Switching to AA
→
VM DTMF Command—Switching to VM
Switching to VM
Switching to AA
Recording message
Listening message
Note
H = Mailbox Number
3.
VM Service
a.
FWD to a Mailbox of the VPS
The PBX sends a mailbox number of the corresponding extension to the VPS when a call is
forwarded from an extension to the VPS. Therefore the caller can leave a message for the called
extension without knowing the mailbox number.
[FWD to the VPS Sequence Selection]
If an extension user sets FWD to the VPS, any incoming call will be forwarded to the VPS. It is
also possible to send the AA command, even in the VM service mode, when calls are forwarded
so that the caller can be directed to an extension rather than a mailbox. This can be performed by
selecting "AA" through system programming.
→ 11.12.1 PBX Configuration—[3-12-1] Group—VM(DTMF) Group—System Settings—Others—
FWD to the VPS Sequence
Answer by Mailbox
(Default)
AA
None
b.
Intercept Routing to a Mailbox of the VPS
The PBX sends a mailbox number of the corresponding extension to the VPS when a CO line call
is intercepted from an extension to the VPS. Therefore the caller can leave a message for the
called extension without knowing the mailbox number.
[Intercept Routing to the VPS Sequence Selection]
Document Version 2017-06
Parameter
Switching to VM command +
Recording message command
(#6 + H [H = Mailbox No.])
Switching to AA command (#8)
(DTMF commands are not sent. Work with default of the VPS.)
Command (Default)
Transmitted Command
In AA Service Mode
21.1.5 Voice Mail DTMF Integration
#6
#8
H
H
In VM Service Mode
Recording message command
(H [H = Mailbox No.])
Switching to AA command (#8)
Feature Manual
437
Advertisement
Table of Contents
