Panasonic KX-NS700 Feature Manual page 333

a.
The SIP phone is connected and registered to the PBX on the PBX's local network. The necessary
settings are configured automatically by the PBX.
b.
The remote IP settings of the SIP phone are configured without first connecting the phone to the PBX.
Once programmed, the SIP phone is sent to the remote location, connected to the network and will
automatically connect to the PBX.
Conditions
•
Voice data (RTP packets) from remote extensions connected to the PBX via the built-in Media Relay
Gateway cannot be sent via a P2P connection. Instead, these calls are connected using the RTP switch
method.
•
IP Softphones connected from a remote location via the Media Relay Gateway do not support the
following features:
–
Background Music (3.1.1 BGM (Background Music))
–
Paging (15.1.1 Paging)
•
For KX-UT SIP phones, extensions that will be configured remotely use HTTPS for transferring the
configuration file. However, a maximum of 20 extensions per site can be connected in this way.
Installation Manual References
5.8.3 Installing SIP Phones at a Remote Site with an External SBC
5.8.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway
PC Programming Manual References
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site—SIP Extension
→Setting parameters assigned to Remote SIP-MLT—NAT - CWMP Server IP Address
→Setting parameters assigned to Remote SIP-MLT—NAT - CWMP Server (HTTP) Port No.
→Setting parameters assigned to Remote SIP-MLT—NAT - CWMP Server (HTTPS) Port No.
→Setting parameters assigned to Remote SIP-MLT—NAT - SIP-MLT Data Download Server (HTTP)
Port No.
→Setting parameters assigned to Remote SIP-MLT—NAT - SIP-MLT Data Download Server (HTTPS)
Port No.
→Setting parameters assigned to Remote SIP-MLT—NAT - SIP Proxy Server IP Address
→Setting parameters assigned to Remote SIP-MLT—NAT - SIP Proxy Server Port No.
→Setting parameters assigned to Remote SIP-MLT—NAT - NTP Server IP Address
→Setting parameters assigned to Remote SIP-MLT—NAT - NTP Server Port No.
→Setting parameters assigned to Remote SIP-MLT—NAT - Keep Alive Packet Type
→Setting parameters assigned to Remote SIP-MLT—NAT - Keep Alive Packet Sending Interval Time
(s)
→Setting parameters assigned to Remote SIP-MLT—NAT - SIP Register Expire Time (s)
→Setting parameters for Networking Survivability, assigned to Remote SIP-MLT—NAT - CWMP Server
IP Address
→Setting parameters for Networking Survivability, assigned to Remote SIP-MLT—NAT - CWMP Server
(HTTP) Port No.
→Setting parameters for Networking Survivability, assigned to Remote SIP-MLT—NAT - CWMP Server
(HTTPS) Port No.
→Control Condition of Remote SIP-MLT—PERIODIC Ability
→Control Condition of Remote SIP-MLT—PERIODIC Packet Sending Interval Time (s)
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site—Port Number—Firmware
Update Port No. for IP-PT/IP-CS (Media Relay)
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site—Media Relay
→Common—NAT - External IP Address
→IP Extension / IP-CS—NAT - MGCP Server Port No.
Document Version 2017-06
18.1.1 Simple Remote Connection
Feature Manual 333