Panasonic KX-NS700 Feature Manual page 52

4.1.6 Call Monitor
•
This feature is available only when the busy extension is in a conversation with another extension or
outside party.
•
This feature will not function when the busy extension:
a.
Has set Executive Busy Override Deny (→ 6.1.7 Executive Busy Override) or Data Line Security (→
5.1.1 Data Line Security).
b.
Is receiving OHCA (→ 14.1.3 OHCA (Off-hook Call Announcement), → 22.1.5 Whisper OHCA).
c.
Is on a conference call with 4 or more participants (→ 4.1.18 Conference, → 6.1.7 Executive Busy
Override, → 15.1.12 Privacy Release).
d.
Is on a doorphone call (→ 5.1.15 Doorphone Call).
e.
Is using Live Call Screening (LCS) (→ 20.1.45 Unified Messaging—Live Call Screening (LCS)).
f.
Has a call on Consultation Hold (→ 4.1.21 Consultation Hold).
g.
When using a sub extension in wireless XDP parallel mode (→ 22.1.6 Wireless XDP Parallel Mode).
•
This feature stops when the busy extension user presses the following buttons during a conversation (→
7.1.1 Fixed Buttons, → 7.1.3 Flexible Buttons):
–
FLASH/RECALL button
–
HOLD button
–
TRANSFER button
–
CONF (Conference) button
–
DSS button
–
EFA button
–
Two-way Record button
–
Two-way Transfer button
–
One-touch Two-way Transfer button
–
Voice Mail (VM) Transfer button
•
Monitoring a Call that is Being Recorded
When a user monitors a call that is being recorded, the user's voice will not be recorded. When an
intercom call is being recorded, call monitoring can be performed on either extension.
Executive Busy Override can also be performed on a call that is being recorded. In this case, the user's
voice will be recorded.
When a member of the original call leaves the conference created by Executive Busy Override, recording
will stop and the remaining extensions will operate as follows:
–
If Automatic Two-way Recording for Manager has been set, recording will start again according to
those settings.
–
If Automatic Two-way Recording for Manager has not been set, one of the parties can press the Two-
way Record button to start a new recording.
A call being recorded between 2 extensions cannot be monitored if the user performing Call Monitoring is
connected via QSIG (TIE).
•
Monitoring a Conference
When a user monitors a three-party conference, the voices of all 3 participants can be heard.
Executive Busy Override can also be performed on a three-party conference. In this case, a four-party
conference will be established.
Call monitoring cannot be performed on a conference on hold.
Call monitoring cannot be performed on a three-party conference where the originator of the conference
is on an outside line (e.g., when calling from a cellular phone).
52 Feature Manual Document Version 2017-06