Panasonic KX-NS700 Feature Manual page 346

18.1.7 SMDR (Station Message Detail Recording)
•
The dialed number including the Host PBX Access code will be recorded on SMDR only if the modified
number setting is selected in the ARS setting for SMDR.
•
When a Host PBX Access code is assigned to a trunk group, calls to extensions of the host PBX are not
recorded on SMDR.
•
A Host PBX Access Code can be used to record only long distance calls on SMDR when a CO line port is
connected directly to the telephone company (not a host PBX). This is allowed when the long distance
code (e.g., "0") is assigned as the Host PBX Access code. All local calls (e.g., calls that do not require a
"0" to be dialed first) are treated as extensions of the telephone company and do not get recorded on
SMDR, because in this case this PBX recognizes the telephone company as the host PBX. Therefore,
only long distance calls are recorded on SMDR.
[Output to a Telnet compatible Terminal Emulator]
•
In order to activate a connection to a terminal emulator, the IP address of the mother board, port number,
user ID ("SMDR"), and password must be entered.
•
If a terminal emulator user incorrectly enters the user ID or password 3 times consecutively, an alarm will
be sent and connection will not be possible for 10 minutes.
•
Through system programming, it is possible to assign the PBX port number and password.
•
The terminal emulator application must be running constantly. If the application is terminated, call records
that occur after the termination will be recorded in the PBX's memory. However, if the number of call
records exceeds the PBX's capacity, older records will be deleted. Also, when the application restarts or
is reconnected, duplicated call records may be output.
[Using SMDR with applications]
•
SMDR data can also be monitored by applications such as Panasonic CA Call Accounting. For more
information, see your application's documentation.
Installation Manual References
4.10 Connection of Peripherals
PC Programming Manual References
10.3 PBX Configuration—[2-3] System—Timers & Counters—Dial / IRNA / Recall / Tone—Dial—Analogue
CO Call Duration Start (s)
10.7.1 PBX Configuration—[2-7-1] System—Class of Service—COS Settings—CO & SMDR—Outgoing CO
Call Printout (SMDR)
14.2 PBX Configuration—[6-2] Feature—Hotel—Main—SMDR for External Hotel Application 2—Printing
Message 1–8
19.1 PBX Configuration—[11-1] Maintenance—Main
→SMDR
→SMDR Options
PT Programming Manual References
[802] SMDR Page Length
[803] SMDR Skip Perforation
[804] SMDR Outgoing Call Printing
[805] SMDR Incoming Call Printing
Feature Manual References
4.1.10 Call Transfer
4.1.22 COS (Class of Service)
5.1.7 DID (Direct Inward Dialing)
5.1.10 DISA (Direct Inward System Access)
346 Feature Manual Document Version 2017-06