Call Log, Incoming - Panasonic KX-NS700 Feature Manual

4.1.5 Call Log, Incoming

Mode 4
These operations must be performed when the held call is intended to be retrieved from another extension using the holding
*1
extension number.
If one of the following occurs frequently with an SLT, choose "Mode 2", "Mode 3", or "Mode 4":
a.
When an SLT user answers a call, a reorder tone is heard or no one is heard on the other end.
b.
When an SLT user goes off-hook, a reorder tone is heard instead of a dial tone.
If a call is not terminated after going on-hook, the above cases occur. To avoid these problems, choose
"Mode 2", "Mode 3", or "Mode 4". Every call will be terminated unless the Hold feature number is
entered after flashing the hookswitch in Mode 2, Mode 3, and Mode 4.
•
Hold Alarm tone pattern has a default. (→ 23.2 Tones/Ring Tones)
PC Programming Manual References
10.3 PBX Configuration—[2-3] System—Timers & Counters—Dial / IRNA / Recall / Tone
→Recall—Hold Recall (s)
→Recall—Disconnect after Recall (x60s)
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features
→Call Hold / Call Hold Retrieve
→Call Hold Retrieve : Specified with a Holding Extension Number
→Hold Retrieve : Specified with a Held CO Line Number
10.9 PBX Configuration—[2-9] System—System Options
→Option 1—PT Operation—Automatic Hold by ICM / CO / ICD Group Key
→Option 1—PT Operation—Hold key mode
→Option 5—SLT—SLT Hold Mode
PT Programming Manual References
[200] Hold Recall Time
Operating Manual References
1.3.6 Call Hold
4.1.5 Call Log, Incoming
Description
When a call containing Caller ID information is received by an extension, the information is shown on the
telephone display, notifying the extension user of the caller's identity. This information is also automatically
logged in the Incoming Call Log of the extension, and can be viewed later or used to call that caller back.
Also, depending on system programming, incoming intercom calls (including over a TIE connection) are
logged in the incoming call log.
Each extension and incoming call distribution (ICD) group has its own Incoming Call Log.
Call Log Button
48 Feature Manual
Hold (to be Retrieved from
Another Extension)
Flashing the
hookswitch
+
Hold Feature No.
+
Going on-hook
Hold
*1
Flashing the
hookswitch
+
Hold Feature No.
+
Hold Feature No.
+
Going on-hook
Transfer to CO
Line
Flashing the
hookswitch
+
Hold Feature No. Hold Feature No.
+
CO Line Access Extension No.
No.
Document Version 2017-06
Transfer to
Extension
Flashing the
hookswitch
+
+