Panasonic KX-NS700 Feature Manual page 102

5.1.10 DISA (Direct Inward System Access)
Redial with DTMF " " when receiving a CO line call (before the transfer destination—cellular phone—
answers).
•
It is possible to redial by using the DTMF tone " " before the transfer destination CO line (cellular
phone) answers.
•
If the transfer destination (cellular phone) is a line that does not support answer notification, outgoing
dial completion is considered as answering.
•
If the destination CO line supports End of Call Detection, screened transfer is available. If the
transferring party dials "#" while talking to the called party, the call can be put back on consultation
hold.
•
If the destination CO line does not support End of Call Detection, the call is transferred unscreened.
•
DISA Call Transfer to Outside User
When a call is received through DISA and the receiving extension is set to forward the call to an
extension (including over a TIE connection) or an outside destination, the call can be forwarded
automatically to an outside telephone number if the following conditions are met:
•
An outside telephone number (e.g., a cellular phone number) is registered as the forward destination of
the receiving extension.
•
The forward destination's telephone number is registered in the System Speed Dial of the receiving
extension.
•
The forward destination's telephone number is set in the CLI Destination of the receiving extension.
•
Automatic Walking COS is enabled for the receiving extension.
After a conversation is established with the forward destination (e.g., a cellular phone number), it is
possible to establish a Conference call, perform Call Splitting, and page with a call on hold to transfer the
call. This is the same as DISA Call Transfer from Outside Destination. For details, see "DISA Call
Transfer from Outside Destination".
[Example]
a.
Outside Caller calls Extn. 101 through DISA.
b.
Extn. 101 forwards the call to Cellular Phone-1.
Outside Caller establishes a conversation with Cellular Phone-1.
c.
Cellular Phone-1 presses "#" to put the conversation on hold, and then transfers the call to Cellular
Phone-2.
At this point, the CLIP information shown on Cellular Phone-2 may be one of the following:
Case 1: When Extn. 101 forwarded the call, Automatic Walking COS was performed with Cellular
Phone-1's telephone number.
–
Displayed CLIP: Same as if Extn. 101 made a CO line call.
Case 2: When Extn. 101 forwarded the call, Automatic Walking COS was not performed, and Send
CLIP of CO Caller—when call is transferred to CO (CLIP of Held Party) is set to Enable.
–
Displayed CLIP: Outside Caller's telephone number and name.
Case 3: When Extn. 101 forwarded the call, Automatic Walking COS was not performed and Send
CLIP of CO Caller—when call is transferred to CO (CLIP of Held Party) is set to Disable.
–
Displayed CLIP: The CLIP set for the line that Cellular Phone-1 used to transfer the call.
102 Feature Manual Document Version 2017-06