Data Line Security; Dhcp (Dynamic Host Configuration Protocol) Assignment; Dhcp (Dynamic Host Configuration Protocol) Server - Panasonic KX-NS700 Feature Manual

5.1 D
5.1 D

5.1.1 Data Line Security

Description
Once Data Line Security is set on an extension, communication between the extension and the other party
is protected from signals such as Call Waiting, Hold Recall and Executive Busy Override. Extensions which
have devices connected to them such as modems or fax machines may set this feature to maintain secure
data transmission, by blocking tones or other interruptions during communication.
PC Programming Manual References
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features—Data Line Security Set /
Cancel
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—Option 2—Data
Mode
Operating Manual References
1.3.18 Data Line Security

5.1.2 DHCP (Dynamic Host Configuration Protocol) Assignment

Description
It is possible to assign this PBX as a DHCP client, allowing IP addresses to be received from a DHCP
server over a LAN.
Conditions
•
It is possible to enable this feature through system programming.
Notice
It is important to set your DHCP server to not change the IP addresses of the mother board and DSP
cards once IP telephones are registered to the PBX. The IP telephones will not operate properly if these
IP addresses are changed.
PC Programming Manual References
27.1 Network Service—[1] IP Address/Ports—Basic Settings
→LAN Setting—Obtain an IP address automatically/Use the following IP address
→LAN Setting—IP Address
→DSP IP Setting—Obtain DSP IP address automatically/Use the following DSP IP address

5.1.3 DHCP (Dynamic Host Configuration Protocol) Server

Description
The PBX has a built-in DHCP server. When the DHCP server is enabled, the PBX will automatically assign
IP addresses to other devices on the network, such as IP-PTs.
Using a DHCP server simplifies network management by removing the need to assign IP addresses to
devices manually.
Conditions
•
The DHCP Server feature cannot be used if the PBX's IP address assignment mode is set to DHCP.
84 Feature Manual Document Version 2017-06