Panasonic KX-NS700 Feature Manual page 235

VoIP-DSP Card
Not Installed
Installed
–
Even if you recorded OGMs when no DSP card was installed, recorded OGMs can still be used after
installing a DSP card in the PBX.
•
DSP Resource Usage
Playing back an OGM requires a certain number of DSP resources. If all DSP resources are in use, this
operation cannot be performed. To ensure a minimum level of performance, DSP resources can be
reserved for OGM playback. (→ 5.1.18 DSP Resource Usage)
•
There is no limit to the length of an individual message, but the maximum recording time (all messages
combined) is approximately 20 minutes.
•
The same message can be played to multiple callers simultaneously.
•
Recording Methods
a.
Record voice messages through the extension telephone.
b.
Transfer prerecorded voice messages from an external audio source to the PBX via an external
music port.
•
After recording messages, a manager extension can also play them back for confirmation.
•
A progress tone is sent to a manager extension before recording messages for a preprogrammed time
period, or while clearing a prerecorded message assigned to a floating extension number.
•
When a manager tries to record a message, he or she will hear a ringback tone if a message channel is
in use. When all message ports become idle, the manager will hear the progress tone for a
preprogrammed time period. After that, the PBX will automatically switch to recording mode.
•
Copying messages to and from a PC
Via Web Maintenance Console, messages can be copied to and from a PC.
–
Messages are downloaded to a PC in WAV (G.711a/µ) format.
–
Messages uploaded from a PC must be in one of the following formats: WAV (linear PCM) or WAV (G.
711a/µ).
Installation Manual References
4.3.3 DSP Cards
5.4.1 Easy Setup Wizard
PC Programming Manual References
7.2.5 Utility—File—Message File Transfer PC to PBX
7.2.6 Utility—File—Message File Transfer PBX to PC
10.3 PBX Configuration—[2-3] System—Timers & Counters—DISA / Door / Reminder / U. Conf—DISA—
Progress Tone Continuation Time before Recording Message (s)
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features—OGM Record / Clear /
Playback
11.5.2 PBX Configuration—[3-5-2] Group—Incoming Call Distribution Group—Queuing Time Table—
Queuing Sequence—Sequence 01–16
13.3.2 PBX Configuration—[5-3-2] Optional Device—Voice Message—DISA Message—Floating Extension
Number
Document Version 2017-06
Available
Channels for OGM
2
64
Max. Number of
OGM Message
64
64
14.1.2 OGM (Outgoing Message)
Total recording time
approximately 20 minutes
approximately 20 minutes
Feature Manual 235