Unified Messaging-Autoplay New Message - Panasonic KX-NS700 Feature Manual

20.1.8 Unified Messaging—Autoplay New Message
•
A call between 2 extensions connected via QSIG (TIE) is treated as an external call (regardless of
whether KX-NSN002 [Activation Key for QSIG Network] is installed). To record these types of calls, CO
line (external) calls must be selected as one of the types of calls to record.
•
Recording will automatically stop when the mailbox reaches its capacity. Delete older messages in order
to use this feature again.
•
If the enabled extension has a Two-way Record button assigned to it, the button will flash during
recording. However, that button cannot be used to cancel this feature. The extension cannot cancel this
feature through Communication Assistant (CA) either.
•
An extension whose conversation is being recorded cannot be the target of the following features:
–
Executive Busy Override (→ 6.1.7 Executive Busy Override)
–
Whisper OHCA (→ 22.1.5 Whisper OHCA)
•
Conversations recorded with this feature are backed up via System Backup/Restore (→ 20.1.74 Unified
Messaging—System Backup/Restore).
PC Programming Manual References
7.10 Utility—Automatic Two-way Recording
8.3 Users—Automatic Two-way Recording
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—UM—Two-way
Recording
12.2.1 PBX Configuration—[4-2-1] Extension—Portable Station—Extension Settings—UM—Two-way
Recording
Feature Manual References
6.1.3 E-mail Notification for Manager
Operating Manual References
Manager Operation
3.2.1 User Programming—Automatic Two-way Recording for Manager
20.1.8 Unified Messaging—Autoplay New Message
Description
It is possible to play new messages automatically when a subscriber or the System Manager/Message
Manager logs into his or her mailbox. There is no need to press [1] to receive the new messages.
Conditions
•
If there is more than one new message in the mailbox, it can be set whether or not messages will be
played continuously without system prompts.
→ 21.1 UM Configuration—[2] Class of Service—Mailbox—Play New Messages Sequentially
PC Programming Manual References
21.1 UM Configuration—[2] Class of Service—Mailbox—Autoplay New Message
382 Feature Manual Document Version 2017-06