Operating & Maintaining the Objet30 3D Printer
Starting the Objet30 Printer
6–2
Figure 6-1: The Objet30 3D Printer
CAUTION!
•
Do not attempt to operate the Objet printer before being trained by a
Stratasys customer-support representative.
•
Observe all safety warnings and follow the safety guidelines described
in chapter 2.
1. Turn on the main power switch, located at the back of the printer.
Figure 6-2: Main power cable and switch
The main power switch turns on the Objet printer, which includes the
built‐in computer.
Printer cover
Printing-materials &
waste compartment
Printer stand
DOC-24333 Rev. A