Starting The Printer - Stratasys Objet30 User Manual

Objet30 User Guide
Figure 6-1 The Objet30 3D Printer

Starting the Printer

Caution
Do not attempt to operate the printer before being trained by a Stratasys
l
Customer Support representative.
Observe all safety warnings and follow the safety guidelines described in
l
Chapter 2.
1. Turn on the main power switch, located at the back of the printer.
DOC-34022 Rev. D
Figure 6-2 Main power switch and cable
The main power switch turns on the Objet30 printer, which includes —
the built-in computer.
6 Operating and Maintaining the Objet30 3D Printer
6-3