Remove The Server From The Rack - HPE ProLiant ML30 Gen10 Maintenance And Service Manual

Remove the server from the rack

Remove the server from the rack
WARNING: This server is heavy. To reduce the risk of personal injury or damage to the equipment: WARNING:
Observe local occupational health and safety requirements and guidelines for manual material handling.
Get help to lift and stabilize the product during installation or removal, especially when the product is not fastened
to the rails. Hewlett Packard Enterprise recommends that a minimum of two people are required for all rack server
installations. A third person may be required to help align the server if the server is installed higher than chest
level.
Use caution when installing the server in or removing the server from the rack; it is unstable when not fastened to
the rails.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. If installed, unlock and remove the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
5. Extend the server from the rack .
6. Remove the server from the tray.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 31