HPE ProLiant ML30 Gen10 Maintenance And Service Manual page 42

Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. Back up all server data on the drive.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
6. Remove the front bezel .
7. Remove the access panel .
8. If installed, remove the air baffle .
9. Disconnect all cables from the drive .
10. Remove the non-hot-plug drive cage:
a. Remove the screws.
Retain the screws for future use.
b. Remove the drive cage.
11. Remove the drive:
a. Remove the screws securing the drive.
Retain the screws for future use.
b. Slide the drive out of the drive cage.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 42