HPE ProLiant ML30 Gen10 Maintenance And Service Manual page 50

10. Remove the front I/O cap:
a. Pull the cap from both the ends.
b. Remove the cap from the I/O cable.
11. Remove the front I/O assembly from the rear panel.
To replace the component, reverse the removal procedure.
Removing and replacing the front panel USB ports cable assembly Removing and replacing the front panel USB ports cable assembly
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 50