HPE ProLiant ML30 Gen10 Maintenance And Service Manual page 55

b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If installed, remove the air baffle .
8. Disconnect the drive power and controller cables from the backplane .
9. Remove all drives .
10. Remove the drive cage.
Retain the screws for future use.
11. Remove the drive backplane.
Retain the screws for future use.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 55