Table of Contents
Advertisement
16. If removed, install the expansion board.
17. If removed, install the air baffle.
18. Install the access panel.
19. Install the front bezel.
20. Connect all peripheral cables to the server.
21. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
22. Power up the server .
Re-entering the server serial number and product ID
Re-entering the server serial number and product ID
After you replace the system board, the system serial number and the product ID must be configured:
Procedure
Procedure
1. Access System Utilities. During POST, press F9.
2. On the System Utilities home screen, select System Configuration > BIOS/Platform Configuration (RBSU) > Advanced Options >
Advanced Service Options.
3. Select the Serial Number field and press Enter.
The following warning appears:
The serial number is modified by qualified service personnel and must match the
serial number located on the chassis.
4. Click OK.
5. Type the serial number and press Enter.
6. Select the Product ID field and press Enter.
The following warning appears:
Product ID is modified only by qualified service personnel. This value must match the
product ID located on the chassis.
7. Type the product ID and press Enter.
8. To confirm exiting from system utilities, press the F12
The server automatically reboots.
The procedure is complete.
HPE Trusted Platform Module 2.0 Gen10 Option
HPE Trusted Platform Module 2.0 Gen10 Option
The HPE Trusted Platform Module 2.0 Gen10 Option is not a customer-removable part.
CAUTION: If the TPM is removed from the original server and powered up on a different server, data stored in the TPM
CAUTION:
including keys will be erased.
If you suspect a TPM board failure, leave the TPM installed and remove the system board. Contact a Hewlett Packard Enterprise
authorized service provider for a replacement system board and TPM board.
F12 key.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide
93
Advertisement
Table of Contents
