Removing And Replacing The Non-Hot-Plug Power Supply - HPE ProLiant ML30 Gen10 Maintenance And Service Manual

a. Connect each power cord to the server.
b. Connect each power cord to the power source.
12. Power up the server .

Removing and replacing the non-hot-plug power supply

Removing and replacing the non-hot-plug power supply
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply and the power supply blank WARNING:
to cool before touching them.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If installed, remove the air baffle .
8. Disconnect all power supply cables .
9. Remove the non-hot-plug power supply.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 77