HPE ProLiant ML30 Gen10 Maintenance And Service Manual page 4

Remove the front bezel
Position the tower server for hardware configuration
Remove the access panel
Remove the air baffle
Install the access panel
Install the front bezel
Position the tower server for operation
Removing and replacing the front bezel
Removing and replacing the air baffle
Removing and replacing drives
Removing and replacing an LFF non-hot-plug drive from the media drive bay
Removing and replacing an LFF non-hot-plug drive from the drive cage
Removing and replacing an LFF hot-plug drive
Caution: All bays must be populated
Removing and replacing an SFF hot-plug drive
Removing and replacing media devices
Removing and replacing a SAS LTO tape drive
Removing and replacing a USB RDX drive
Removing and replacing an optical drive
Removing and replacing an internal USB device
Removing and replacing the iLO dedicated network port blank
Removing and replacing the front I/O assembly
Removing and replacing the front panel USB ports cable assembly
Removing and replacing the EMI shield
Removing and replacing the serial port blank
Removing and replacing the four LFF hot-plug drive backplane
Removing and replacing the eight SFF hot-plug drive backplane
Removing and replacing the M.2 SSD/dedicated iLO/serial port enablement board
Removing and replacing an M.2 SSD
Removing and replacing an expansion board
Removing and replacing a Smart Array standup storage controller
DIMM-processor compatibility
Removing and replacing a DIMM
Removing and replacing a PCI fan
Removing and replacing the system fan
Removing and replacing the energy pack
Removing and replacing the energy pack holders
Removing and replacing a heatsink
Removing a heatsink
Replacing a heatsink
Removing and replacing a processor
Removing a processor
Replacing a processor
Removing and replacing the non-hot-plug power supply