Removing And Replacing A Processor - HPE ProLiant ML30 Gen10 Maintenance And Service Manual

7. Connect all peripheral cables to the server.
8. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
9. Power up the server .

Removing and replacing a processor

Removing and replacing a processor
Removing a processor Removing a processor
CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace or CAUTION:
install the processor in this server.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static precautions before beginning CAUTION:
any installation, removal, or replacement procedure. Improper grounding can cause electrostatic discharge.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
Torque screwdriver
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If installed, remove the air baffle .
8. Allow the heatsink to cool.
9. Remove the heatsink:
a. Disconnect the heatsink fan cable.
b. Loosen one pair of diagonally opposite screws halfway, and then loosen the other pair of screws.
c. Completely loosen all screws in the same sequence.
d. Remove the heatsink from the processor backplate.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 70