Removing And Replacing The System Board - HPE ProLiant ML30 Gen10 Maintenance And Service Manual

13. Connect all peripheral cables to the server.
14. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
15. Power up the server .
16. Properly dispose of the old battery.
For more information about battery replacement or proper disposal, contact an authorized reseller or an authorized service
provider.

Removing and replacing the system board

Removing and replacing the system board
Removing the system board Removing the system board
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If installed, remove the air baffle .
8. Disconnect all cables connected to the system board.
9. If installed, remove the expansion board .
10. Remove the system fan.
11. If installed, remove the M.2 SSD/dedicated iLO/serial port enablement board .
12. Remove all DIMMs.
13. If installed, remove the energy pack .
14. If installed, remove the energy pack holders .
15. Allow the heatsink to cool.
16. Remove the heatsink:
a. Disconnect the heatsink fan cable.
b. Loosen one pair of diagonally opposite screws halfway, and then loosen the other pair of screws.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 84