Removing And Replacing A Pci Fan - HPE ProLiant ML30 Gen10 Maintenance And Service Manual

Removing and replacing a PCI fan

Removing and replacing a PCI fan
NOTE: A PCI fan is also required while the server is in rack mode. NOTE:
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If installed, remove the air baffle .
8. Remove the PCI fan module:
a. Disconnect and release the fan cable from the metal tab.
b. Remove the screws.
c. Remove the PCI fan.
To replace the component, reverse the removal procedure.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 63