Removing And Replacing The Air Baffle - HPE ProLiant ML30 Gen10 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Removing and replacing the air baffle

Removing and replacing the air baffle
CAUTION: For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers, or CAUTION:
blanks installed. If the server supports hot-plug components, minimize the amount of time the access panel is open.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. Remove the air baffle:
a. Remove the front end of the baffle from the chassis.
b. Remove the baffle from the slots on the rear chassis.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 39