HPE ProLiant ML30 Gen10 Maintenance And Service Manual page 48

If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If installed, remove the air baffle .
8. Remove the USB device from the internal USB port.
To replace the component, reverse the removal procedure.
Removing and replacing the iLO dedicated network port blank Removing and replacing the iLO dedicated network port blank
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If installed, remove the air baffle .
8. Remove the iLO dedicated network port blank.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 48