Removing And Replacing The Front Bezel - HPE ProLiant ML30 Gen10 Maintenance And Service Manual

Removing and replacing the front bezel

Removing and replacing the front bezel
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel:
a. If locked, unlock the front bezel.
b. Open the front bezel.
c. Pull the front bezel away from the chassis.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 38