Replacing The Pick-Up Roller - Konica Minolta bizhub 500 Service Manual

Field Service Ver. 1.0 Feb. 2006
2.1.3

Replacing the Pick-up Roller

A. Periodic replaced part/cycle
• Pick-up Roller: Every 750,000 prints (Actual replacement cycle: Every 300,000 prints)
NOTE
• Replace the Separation Roller Assy, Feed Roller and Pick-up Roller at the same time.
B. Procedure
[2]
[5]
1. Remove the Rear Cover and the Rear
[1]
2. Remove the Tray.
3. Remove the Separation Roller Mounting
4. Disconnect the connector [1] from the
4061f2c213na
5. Remove four screws [2] and the Paper
[3]
[2]
4061f2c214na
6. Remove two screws [4] and remove the
[4]
4061f2c215na
2. PERIODIC CHECK
Right Cover.
(See P.11)
Plate Assy.
(See P.3)
PC Control Board (PCCB).
Feed Unit [3].
Separation Roller Mounting Plate Assy
[5] together with frame.
7