Konica Minolta bizhub 500 Service Manual page 489

10. SERVICE MODE
10.2 Setting Method
This machine is provided with a service mode for various types of adjustments/settings. Data adjusted and/or
set in this mode are stored in the NVRAM board (NRB).
10.2.1 Start and exit of the service mode
You can access the service mode while the power is both turned ON and OFF. In either way, the started service
mode is the same, but how to exit differs.
A. Starting and exiting service mode while the power is ON
1.
Check to see if the regular copy screen is displayed.
2.
Press the Utility/Counter key.
3.
"Meter Count/ Utility screen"
Press [Details].
4.
"Meter Count screen"
Press the Stop key and key pad in the order shown below.
Stop → 0 → 0 → Stop → 0 → 1
Note
• When the CE password is set, a password is required to input to enter the service mode.
5.
"Service Mode screen"
The service mode is in the start-up condition.
6. Select an item to set.
The setup screen of each item is displayed.
7. Conduct required operations, and press [END/OK] after completion of the operations.
The setting made at step 6 becomes effective.
8.
"Service Mode screen"
Press [Exit] to return to the regular copy screen.
B. Starting and exiting service mode while the power is OFF
1.
While pressing the Utility/Counter key, turn ON the power switch (SW2).
2.
Trouble reset screen appears.
3.
Press the [Trouble reset].
4.
On the Operation panel, press the following keys.
Stop → 0 → 0 → Stop → 0 → 1
5.
Service Mode screen appears.
Note
• When the CE password has been set, you must enter the password to enter the service mode.
6.
Press the key for an item you want to configure.
The setting screen for each item appears.
7.
Conduct necessary operations and turn OFF the SW2 after completion of operations.
8.
The new settings become effective after restart.
156
Field Service Ver1.0 Feb.2006