Theory of Operation Ver1.0 Feb.2006
COMPOSITION/OPERATION
5. OVERALL CONFIGURATION
5.1
Time chart when the power is turned ON
Item
Normal
Scanner motor
rotation
(M2)
Reverse
rotation
Exposure lamp (L1)
Fusing heater lamp /1 (L2)
Fusing heater lamp /2 (L3)
Fusing motor (M11)
Drum motor (M1)
Developing motor (M3)
Polygon motor (M5)
Laser (LDB)
Paper lift motor /1 (M7)
Upper limit sensor /1 (PS6)
Paper lift motor /2 (M8)
Upper limit sensor /2 (PS13)
[1]
Fusing heater lamps /1 (L2) and /2 (L3) turn
ON early
[2]
Power switch (SW2) turns ON
[3]
Initial communication between the overall
control board (OACB) and the printer control
board (PRCB)
[4]
Shading correction
Note
• Each operation varies according to the setting of the software DipSW in the service mode.
• The power is turned ON with DF closed.
• The power is turned ON with the lift plate of the tray down.
[1] [2]
[3][4]
[5]
[6]
[5]
Drum motor (M1) turns ON
[6]
Dot diameter adjustment starts
[7]
The fusing temperature gets to the pre-
scribed temperature to start the preliminary
rotation for fusing
[8]
Dot diameter adjustment completed
[9]
Warming up completed
5. OVERALL CONFIGURATION
[7]
[8]
50gat2e001na
[9]
9