Center Staple Skew Adjustment - Konica Minolta bizhub 500 Service Manual

4. MECHANICAL ADJUSTMENT
4.2

Center Staple Skew Adjustment

NOTE
Make this adjustment after any of the following procedures has been performed.
• When Staple Unit 1 or 2 has been replaced.
• When skew occurs in the position of the center staple.
A
[1]
[4]
[3]
[2]
24
1. Set to Fold & Staple mode and make a
copy. Measure the width A of the paper.
Specification: 0 ± 1.5 mm
2. If the staple position is skewed as
shown on the left, make the following
adjustment.
[1] Exit direction
4511f3c003na
3. Release the lock release lever [2] of the
Saddle Unit.
4. Loosen the adjustment screw [3] and
move the lock member [4] to the left to
make the adjustment.
• If the staple position is skewed opposite
to the figure of step 2, move the lock
member to the right to make the adjust-
ment.
5. Make another copy and check the staple
position.
4511f3c004na
Field Service Ver. 1.0 Feb. 2006