Konica Minolta bizhub 500 Service Manual page 608

Field Service Ver1.0 Feb.2006
Classification Jam code
FS J-2006
FS-510 J-2007
FS-511 J-2008
RU J-2009
FS-511 J-2010
MT
SD
Conveyance J-3000
J-3100
Fusing J-3200
Reversing J-3300
J-3400
Other J-5001
Cause
While in the print, the front door
opens.
While in the print, the guide plate
switch (SW4) turns OFF.
While in the up drive operation of the
tray, the shutter switch (SW2) turns
ON.
While in the print, FS-511 comes off
from the main body.
While in the print, the front door
opens.
While in the print, the upper door
opens.
While in the print, the right door
opens.
While in the print, the saddle-stitching
section opens.
The registration sensor (PS1) does
not turn OFF within a specified period
of time after the registration clutch
(CL1) turns ON.
The fusing exit sensor (PS3) does not
turn ON within a specified period of
time after the registration clutch (CL1)
turns ON.
The fusing exit sensor (PS3) does not
turn OFF within a specified period of
time after the PS3 turns ON.
The reverse sensor (PS27) does not
turn ON within a specified period of
time after the fusing exit sensor (PS3)
turns ON.
The reverse sensor (PS27) does not
turn OFF within a specified period of
time after the PS27 turns ON.
A print start signal is not sent out from
the overall control board (OACB)
within a specified period of time after
the registration sensor (PS1) turns
ON.
Resulting Correction
operation
The main body Remove jammed paper
and the optional if any from optional
device stop device / main body.
immediately.
The printer sec- Open ADU and remove
tion stops jammed paper if any.
immediately.
The main body Open the right door of
and the optional PC, the vertical convey-
device stop ance door of the main
immediately. body and ADU and
remove jammed paper
if any.
12. JAM CODE
275